Pascal Control - Canon iR C3380 series Service Manual

7.3.6 PASCAL Control

/ / / / iR C3380i / iR C3380 / iR C2880i / iR C2880
This is the control for the stabilization of the image gradation density characteristic. It is executed when 'auto gradation correction $ full correction' of the user mode
is selected. The gradation density of the test-printed patch pattern is read by the reader, and the image density correction table is created. By executing this procedure,
the correction of the image gradation density characteristic varying due to the environmental change or the deterioration of photosensitive drum.
1. Timing for Start-up
At the time of calibration (while executing 'auto gradation correction $ full correction' of the user mode)
2. Control Description
When the specified conditions are satisfied, the main controller prints three kinds of the stored patch pattern (see MEMO) on paper. Service technician sets the test
print to the reader. Reader reads the gradation density of the patch pattern from the test print. After that, the main controller creates the image gradation density
correction table from the gradation density data of the patch pattern read by the reader. In this control, the gradation correction for all colors is executed regardless
of replaced drum cartridge.
3. Operation Flow
1st patch
Target
Correction
Bk1
range
0
Vdc
2nd patch
Bk2
Target
Bk1
0
Vdc
4 patches max.
Start-up
DC controller
Patch pattern formation
UN16
Patch reading
DC controller
Black D-max correction
table formation
Within correction range?
Yes
DC controller
Developing bias determination
(VDC)
F-7-23
Chapter 7
No
0013-9598
7-17