Formatting The Hdd - Canon iR C3380 series Service Manual

Chapter 18
<Procedure>
1) If the machine is on, go through the HDD shut-down instructions, and turn off the main power.
2) Connect the USB device to the USB port.
3) Put the machine in download mode (normal or safe).
4) Go through the instructions on the control panel, and press the appropriate key.
[3] -> [0]: execute download / other that [0]: go back to Menu screen
5) While downloading is under way, the control panel screen shows its progress. At the end of downloading, a message will appear asking you to press a key. Press
the appropriate key. If the machine is in normal mode, the shut-down sequence will start.
6) When a message appears asking you to turn off the power, turn off the main power, remove the USB device, and turn the main power switch back on.
7) Upon start-up, the machine starts writing the system software to the system area of the HDD or the flash ROM. At the end of writing, a message will appear
asking you to turn off and then back on the power. Turn off and then on the main switch.

18.6.6 Formatting the HDD

/ / / / iR C3380i / iR C3380 / iR C2880i / iR C2880
This function is available only when the machine is in safe mode.
[4]: Format HDD (in the presence of BOOTDEV)
Use it to format the HDD for BOOTDEV partition.
[4]: Format HDD (ALL) (in the absence of BOOTDEV, as when replacing with new HDD)
Use it to format the HDD for full partition.
<Procedure>
Go through the following to format the HDD for BOOTDEV partition:
1) If the machine is on, go through the HDD shut-down instructions, and turn off the main power.
2) Connect the USB device to the USB port.
3) Start up the machine in safe mode.
4) Follow the instructions on the control panel, and press the appropriate key.
[4] -> [0]: go to Partition Selection screen / other that [0]: go back to Menu screen
18-26
F-18-57
F-18-58
F-18-59
0014-4508