Pressure Roller; Before Removing Pressure Rolle; Removing Pressure Roller - Canon iR C3380 series Service Manual

[4]
[1]
9) From the fixing film unit [1], slide the 2 leaf springs [2] in the direction of
the arrow, and remove them; then, remove the separation guide [3].
[2]
[3]
Points to Note when Attaching the Shutter Unit
When attaching the shutter unit [1], it could damage the fixing film. There-
fore, be sure to go through the following procedure.
1) Cover the fixing film with the protection sheet [2].
[2]
2) Fit the shutter unit [1] onto the positioning pin [2].
[5]
[2] [3]
F-9-16
[2]
[1]
F-9-17
[1]
F-9-18
3) Tighten the 5 screws [1], and pull out the protection sheet [2].
[2]

9.5.3 Pressure Roller

9.5.3.1 Before Removing Pressure Rolle

/ / / / iR C3380i / iR C3380 / iR C2880i / iR C2880
1) Remove the fixing film unit. (page 9-12)[Removing Fixing Film Unit]

9.5.3.2 Removing Pressure Roller

/ / / / iR C3380i / iR C3380 / iR C2880i / iR C2880
1) Remove the screw [1]; then, remove the inlet guide [2] by sliding in the
direction of the arrow.
2) Open the jam removal door [1], and inset the screwdriver [2] as indicated
in the following figure.
[2]
3) By lifting one side of the pressure roller [1], remove the bush [2] and
bearing [3].
Chapter 9
[2]
[1]
F-9-19
[1]
F-9-20
[1] [2]
F-9-21
[1]
F-9-22
0013-8776
0013-8777
9-13