Ricoh D146 Service Manual page 1877

Hide thumbs Also See for D146:
Table of Contents

Advertisement

6-7
Not used
System Switch 0B - Not used (Do not change the factory settings.)
System Switch 0C - Not used (Do not change the factory settings.)
System Switch 0D - Not used (Do not change the factory settings.)
No
Function
0-1
Not used
Enable/disable for direct
sending selection
2
0: Direct sending off
1: Direct sending on
Action when the external
handset goes off-hook
3
0: Manual tx and rx operation
1: Memory tx and rx operation
(the display remains the same)
4-7
Not used
No
0
Country/area code for functional
to
settings (Hex)
SM
Do not change the factory settings
System Switch 0E (SP No. 1-101-015)
Do not change the settings.
Direct sending cannot operate when the
capture function is on during sending. Setting
this switch to "1" enables direct sending without
capture.
Setting this switch to "0" masks the direct
sending function on the operation panel so
direct sending with ScanRouter cannot be
selected.
0: Manual tx is possible while the external
handset is off-hook. However, manual tx during
handset off-hook may not be sent to a correct
direction. Manual tx is not possible.
1: The display stays in standby mode even
when the external handset is used, so that
other people can use the machine for memory
tx operation. Note that manual tx and rx are not
possible with this setting.
Do not change these settings.
System Switch 0F (SP No. 1-101-016)
Function
Comments
Comments
This country/area code determines the
factory settings of bit switches and RAM
101
D163

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

D147D149D148D150

Table of Contents