Energy Saver Settings - Fuji Xerox ApeosPort-IV C5575 Administration Manual

Print-On-Demand Duration
Specify the duration for the machine to receive a print job from web applications. Unless the
machine receives full data of the print job within the specified period of time, the machine
does not process the print job.
Specify the time duration between 0 and 255 minutes in 1 minute increments. If you specify
[0], it means that there is no time limit set on the machine for receiving data.
Note

Energy Saver Settings

You can configure the following settings of Energy Saver mode.
Energy Saver Timers
The Energy Saver mode has two modes: the Low Power and Sleep modes. When a specified
period of time has elapsed, the machine switches to these modes in the following order to
reduce power consumption.
Last operation on the machine
For more information on the setting procedure, refer to "Energy Saver Mode" (P.23).
Note
From Last Operation to Low Power Mode
Specify a time period between 1 and 240 minutes in 1 minute increments to enter the Low
Power mode after the last operation.
Note
From Last Operation to Sleep Mode
Specify a time period between 1 to 240 minutes in 1 minute increments to enter the Sleep
mode after the last operation.
Note
Energy Saver Deactivation
Select whether to disable the Energy Saver mode fully or partially when exiting the mode.
Deactivate All
All devices of the machine exit the Energy Saver mode.
Deactivate Partially As Required
Only the devices necessary for the operation exit the Energy Saver mode.
You can select from [Always On] or [When Printing / Job Auto Processing].
Note
Deactivation With Smart WelcomEyes
Set whether or not to allow Smart WelcomEyes to deactivate the Energy Saver mode.
• When you send a print job that contains a large amount of data or a print job whose contents take a
while to be processed, transmission may be timed out before the machine receives the last page of
the print job. If transmission is timed out, the print job will be canceled. Therefore, you should
consider the machine usage when you set the time duration.
Low Power mode
• You cannot configure the machine not to switch to the Low Power mode or the Sleep mode.
• The timer does not start counting until the operator leaves the detectable area of Smart
WelcomEyes. The Access Lamp lights up while the machine detects human presence.
• Configure the [From Last Operation to Sleep Mode] time to be longer than the [From Last Operation
to Low Power Mode] time.
• The timer does not start counting until the operator leaves the detectable area of Smart
WelcomEyes. The Access Lamp lights up while the machine detects human presence.
• This is not effective when [EtherTalk Compatible - Port Status] is set to [Enabled]. For more
information on the port setting, refer to "Port Settings" (P.196).
Common Service Settings
Sleep mode
5
147