Step 3 Configuration On The Computer; Centreware Internet Services Setting Items - Fuji Xerox ApeosPort-IV C5575 Administration Manual

7 Printer Environment Settings
address. The configuration of an IP address, a subnet mask, and a gateway address is not
required.
For information on how to set an IP address, refer to "Protocol Settings" (P.201).
4
Select [Close] repeatedly until the [Tools] screen is displayed.
5
Select [Close].
Note
6
Print a configuration report to confirm that the SMB port is enabled and that TCP/IP is set
up correctly.
For information on how to print a configuration report, refer to "Print Reports" (P.106).
Note
7
Configure the other SMB settings as necessary.
For information on the SMB settings, refer to "CentreWare Internet Services Setting Items" (P.328).

Step 3 Configuration on the Computer

To print from the machine, you need to install a print driver on your computer.
For information on the supported operating systems, refer to "Supported Operating Systems" (P.320).
For information on the driver installation procedures, refer to the manual contained in the Driver CD Kit.

CentreWare Internet Services Setting Items

7
You can configure the following setting items using CentreWare Internet Services:
For details on the setting items, click [Help] at the upper right corner of the CentreWare Internet Services screen to see help.
Important • To display the online help for CentreWare Internet Services, users need to have the environment to
For information on how to start CentreWare Internet Services, refer to "Starting CentreWare Internet Services" (P.312).
Spool Destination for Jobs
([Properties] > [General Setup] > [Memory Settings] > [SMB])
Port Settings
Transport Protocol
Maximum Connections
Workgroup
Server Name
TBCP Filter
Note
Unicode Support
Auto Master Mode
Password Encryption
Obtain WINS Server Address Automatically
Primary Server IP Address & Port
Secondary Server IP Address & Port
330
• Rebooting the machine may be required depending on the settings. When a message displayed on
the screen, follow the message and reboot the machine.
• If NetBEUI protocol is used as the transport protocol, select [NetBEUI] on the [Port Settings] screen
for SMB in CentreWare Internet Services.
connect to the internet. The communication fee shall be borne by you.
• The TBCP filter can be configured when the Adobe PostScript 3 Kit (optional) is installed.