Configuration Of Store To Folder; Step 1 Enabling Port And Setting Up Tcp/Ip - Fuji Xerox ApeosPort-IV C5575 Administration Manual

9 Scanner Environment Settings

Configuration of Store to Folder

This section describes configuration procedures to use the Store to Folder service on the
machine.
The following shows the reference section for each procedure.

Step 1 Enabling Port and Setting up TCP/IP

Using Network Scanner Utility3 (Scan Driver and Stored File Manager 3), which supports
WebDAV protocol, and EasyOperator (application) provided by Fuji Xerox, enable the
WebDAV, SNMP, and SOAP ports and set up an IP address.
EasyOperator allows you to retrieve files stored in a folder of the machine without a scan
driver.
Note
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note
9
3) Select [Tools] on the [Services Home] screen.
2
Enable the port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SNMP], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close].
7) Select [SOAP], and then select [Change Settings].
8) Select [Port Status], and then select [Change Settings].
9) Select [Enabled], and then select [Save].
10) Select [Close].
11) Select [WebDAV], and then select [Change Settings].
12) Select [Port Status], and then select [Change Settings].
13) Select [Enabled], and then select [Save].
14) Select [Close] repeatedly until the [Tools] screen is displayed.
346
Step 1 Enabling Port and Setting up TCP/IP......................................................................................................................... 346
Step 2 Registering a Folder ....................................................................................................................................................... 347
Step 3 Configuring a Computer ............................................................................................................................................... 347
• You can configure the settings using CentreWare Internet Services. For information on how to use
CentreWare Internet Services, refer to "Configuring Machine Settings Using CentreWare Internet
Services" (P.313).
displayed on the screen, and select [Enter].
• The default user ID is "11111".
• The default passcode is "x-admin".