Ftp Client; Upnp Discovery - Fuji Xerox ApeosPort-IV C5575 Administration Manual

SNMP
Port Status
Select [Enabled] to use SNMP, when you use any web applications manufactured by Fuji
Xerox to control the machine on the network.
SIP
Port Status
Select [Enabled] to use SIP, when you use IP fax (SIP) transmission.
Port Number
Enter a port number for use IP fax (SIP).
The default value is 5060.
Important • Do not use any numbers assigned to other ports.
Note

FTP Client

Port Status
Select [Enabled] when you use the Scan to PC service with FTP transmission.
Note
Receive E-mail
Port Status
Select [Enabled] when you receive e-mails or Internet faxes.
Send E-mail
Port Status
Select [Enabled] when you send e-mails or Internet faxes.
E-mail Notification Service
Port Status
Select [Enabled] when you use the E-mail Notification Service. The E-mail Notification
Service notifies you of the machine status or the completion of a print job and a direct fax
job by e-mail.
Note
Important • To display the online help for CentreWare Internet Services, users need to have the environment to

UPnP Discovery

Port Status
Select [Enabled] to use UPnP.
• IP fax (SIP) is not available for some models.
• Select a communication mode to send data scanned via FTP from [Passive Mode] and [Active
Mode]. [Passive Mode] is selected by factory default. You can change the setting from CentreWare
Internet Services.
• [Consumables Status], [Parts Status], [Paper Tray Status], [Output Tray Status], [Jam Status],
[Interlock Status], and [Fault Notice] are notified as the machine status.
• You can configure the E-mail Notification Service in CentreWare Internet Services. For more
information, refer to the help of CentreWare Internet Services.
connect to the internet. The communication fee shall be borne by you.
Connectivity & Network Setup
199
5