Configuration Of Store To Wsd; Step 1 Preparations; Step 2 Enabling Port - Fuji Xerox ApeosPort-IV C5575 Administration Manual

9 Scanner Environment Settings

Configuration of Store to WSD

This section describes how to configure the machine to use the Store to WSD service.
Note
The following shows the reference section for each procedure.

Step 1 Preparations

The following environment is required to use the Store to WSD feature on the machine.
The following operation system must be installed on a destination computer.

Step 2 Enabling Port

To use the Store to WSD service, enable the WSD scan port. The following describes the
configuration procedures on the machine.
Note
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
9
Note
3) Select [Tools] on the [Services Home] screen.
2
Enable the port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [WSD], and then select [Change Settings].
4) Select [WSD Scan - Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.
3
Select [Close].
Note
4
Print a configuration report to confirm that the WSD port is set up correctly.
For information on how to print a configuration report, refer to "Print Reports" (P.106) .
362
• WSD stands for Web Services on Devices.
Step 1 Preparations..................................................................................................................................................................... 362
Step 2 Enabling Port ................................................................................................................................................................... 362
Step 3 Confirmation on the Computer................................................................................................................................... 363
- Microsoft Windows 7
- Microsoft Windows Vista Service Pack 2
• You can configure the settings using CentreWare Internet Services. For information on how to use
CentreWare Internet Services, refer to "Configuring Machine Settings Using CentreWare Internet
Services" (P.313).
displayed on the screen, and select [Enter]. When a passcode is required, select [Next]
and enter the system administrator's passcode, and select [Enter].
• The default user ID is "11111".
• The default passcode is "x-admin".
• Rebooting the machine may be required depending on the settings. When a message displayed on
the screen, follow the message and reboot the machine.