Changing The Paper Size For Tray 3 (When Tandem Tray Module Is Installed) - Fuji Xerox ApeosPort-IV C5575 Administration Manual

2 Paper and Other Media
4
Load and align the edge of the paper against
the left side of the tray, with the side to be
copied or printed on facing up.
Important • Do not load paper above the maximum fill
5
Push the tray in gently until it stops.
Important • When inserting the tray, push it gently.
Note
For more information on paper type settings, refer to "Changing the Paper Settings" (P.60).

Changing the Paper Size for Tray 3 (When Tandem Tray Module is Installed)

2
The following describes how to change paper size in Tray 3 when the Tandem Tray Module
is installed.
1
Pull out Tray 3 until it stops.
Make sure to pull out the tray
slowly. When the tray is being
pulled out with force, the tray may
possibly hit your knees or other
parts of your body causing injuries.
Important • While the machine is processing a job, do not pull out the tray that is being used for the job.
2
Remove any paper loaded in the tray.
3
Pinch the paper guide and slide it to the desired
paper size.
4
Load and align the edge of the paper against
the left edge of the tray, with the side to be
copied or printed on facing down.
Important • Do not load paper above the maximum fill
5
While pinching the paper guide, lightly align
the edge to the edge of the paper.
6
Push the tray in gently until it stops.
Note
56
line ("MAX" in the right figure).
Forcibly pushing the tray in may cause
machine malfunction.
• Affix the paper size label to the front of the
paper tray.
CAUTION
• To prevent paper jams or erroneous detection of loaded paper in a tray by the machine, do not add
paper on top of any remaining paper in the tray.
line. It may cause paper jams or machine
malfunction.
• Affix the paper size label to the front of the paper tray.