Replacing Staple Cartridge (For Finisher-C1 Or Finisher-C1 With Booklet Maker) - Fuji Xerox ApeosPort-IV C5575 Administration Manual

3 Maintenance
6
Push the staple cartridge into the finisher until
it clicks into place.
7
Close the finisher front cover.
Note
Replacing Staple Cartridge (for Finisher-C1 or Finisher-C1 with Booklet
Maker)
When the optional Finisher-C1 or optional Finisher-C1 with Booklet Maker is installed and
3
the staple cartridge needs to be replaced, a message appears on the touch screen. When this
message appears, load a new staple case into the staple cartridge.
This section explains how to replace the staple cartridge in the Finisher-C1 with Booklet
Maker, as an example. You can apply the same procedures to the Finisher-C1.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance.
Note
1
Make sure that the machine is not operating,
and open the finisher front cover.
2
Grasp the handle R1 of the staple cartridge
holder, and pull out the holder to the right,
towards you.
78
• If the front cover is not closed completely, a message appears and the machine will remain paused.
Use only staple cartridges recommended by Fuji Xerox.
• To order a staple cartridge, contact our Customer Support Center.