Chapter 31 Remote Node Setup; Introduction To Remote Node Setup; Remote Node Setup; Remote Node Profile Setup - ZyXEL Communications ZyWALL 5 User Manual

This chapter shows you how to configure a remote node.

31.1 Introduction to Remote Node Setup

A remote node is required for placing calls to a remote gateway. A remote node represents
both the remote gateway and the network behind it across a WAN connection. Note that when
you use menu 4 to set up Internet access, you are actually configuring a remote node. The
following describes how to configure Menu 11.1 - Remote Node Profile, Menu 11.1.2 -
Remote Node Network Layer Options, Menu 11.1.4 - Remote Node Filter and Menu
11.1.5 - Traffic Redirect Setup.

31.2 Remote Node Setup

From the main menu, select menu option 11 to open Menu 11 - Remote Node Setup (shown
below).
Then enter 1 to open Menu 11.1 - Remote Node Profile and configure the setup for your
WAN port. Enter 2 to open Menu 11.2 Remote Node Profile (Backup ISP) and configure the
setup for your Dial Backup port connection (see

Figure 244 Menu 11: Remote Node Setup

Menu 11 - Remote Node Setup
1. ChangeMe (ISP, SUA)
2. -Dial (BACKUP_ISP, SUA)

31.3 Remote Node Profile Setup

The following explains how to configure the remote node profile menu.

Chapter 31 Remote Node Setup

Remote Node Setup
Enter Node # to Edit:
C
H A P T E R
Chapter 27 on page
ZyWALL 5 User's Guide
3 1
403).
431