Table of Contents
Advertisement
Prestige 2302R Series User's Guide
19.2.1 IP Alias Setup
IP alias allows you to partition a physical network into different logical networks over the
same Ethernet interface. The Prestige supports three logical LAN interfaces via its single
physical Ethernet interface with the Prestige itself as the gateway for each LAN network.
Use menu 3.2 to configure the first network. Move the cursor to the Edit IP Alias field, press
[SPACE BAR] to choose Yes and press [ENTER] to configure the second and third
networks.
Press [ENTER] to open Menu 3.2.1 - IP Alias Setup, as shown next.
Figure 101 Menu 3.2.1: IP Alias Setup
Use the instructions in the following table to configure IP alias parameters.
Table 65 Menu 3.2.1: IP Alias Setup
FIELD
IP Alias 1, 2
IP Address
IP Subnet Mask
RIP Direction
Version
Incoming protocol
filters
186
Menu 3.2.1 - IP Alias Setup
IP Alias 1= Yes
IP Address=
IP Subnet Mask= 0.0.0.0
RIP Direction= None
Version= RIP-1
Incoming protocol filters=
Outgoing protocol filters=
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
Enter here to CONFIRM or ESC to CANCEL:
DESCRIPTION
Choose Yes to configure the LAN network for the Prestige.
Enter the IP address of your Prestige in dotted decimal notation.
Your Prestige will automatically calculate the subnet mask based on the IP
address that you assign. Unless you are implementing subnetting, use the subnet
mask computed by the Prestige.
Press [SPACE BAR] and then [ENTER] to select the RIP direction. Options are
Both, In Only, Out Only or None.
Press [SPACE BAR] and then [ENTER] to select the RIP version. Options are RIP-
1, RIP-2B or RIP-2M.
Enter the filter set(s) you wish to apply to the incoming traffic between this node
and the Prestige.
Chapter 19 Menu 3 LAN Setup
Advertisement
Table of Contents
Troubleshooting
