Editing Tcp/Ip Options (With Ethernet Encapsulation); Figure 7-4 Menu 11.3 - Remote Node Network Layer Options; Table 7-4 Remote Node Network Layer Options Menu Fields - ZyXEL Communications ZyWALL 10/10 User Manual

7.2

Editing TCP/IP Options (with Ethernet Encapsulation)

Move the cursor to the Edit IP field in menu 11.1, press [SPACE BAR] to select Yes. Press [ENTER] to
open Menu 11.3 - Network Layer Options.
Press Space Bar to Toggle
Figure 7-4 Menu 11.3 — Remote Node Network Layer Options
The next table gives you instructions about configuring remote node network layer options.

Table 7-4 Remote Node Network Layer Options Menu Fields

FIELD
IP Address If your ISP did not assign you an explicit IP address, select Dynamic;
Assignment otherwise select Static and enter the IP address & subnet mask in the
following fields.
IP Address If you have a Static IP Assignment, enter the IP address assigned to you
by your ISP.
IP Subnet If you have a Static IP Assignment, enter the subnet mask assigned to
Mask you.
Gateway IP If you have a Static IP Assignment, enter the gateway IP address
Addr assigned to you.
Network Use [SPACE BAR] to select either Full Feature, None or SUA Only. See
Address the NAT chapter for a full discussion on this feature.
Translation
Remote Node Setup
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Addr= N/A
Network Address Translation= SUA Only
Metric= N/A
Private= N/A
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
DESCRIPTION
ZyWALL 10/10 II/50 Internet Security Gateway
EXAMPLE
Dynamic
SUA Only
7-7