Transaxle - Toro Workman HDX Service Manual

Transaxle

Problem
Noisy operation.
Difficult shifting.
Gears make clashing noise when shifting.
Transaxle sticks in gear.
Drive Train
Possible Causes
Low oil level in transaxle.
Damaged or worn bearings.
Gears worn, scuffed or broken.
Excessive end play in countershaft.
Gears loose on shaft.
Excessive wear of differential side gear liners and
pinion liners.
Excessive wear of splined slider on axle drive joints.
Clutch not releasing.
Shift cable out of adjustment.
Shift cable damaged.
Shifter cap screw loose (at operator station).
Loose shift lever on transaxle.
Cable clamp securing cables near shifter is loose.
Sliding gear tight on shaft or splines.
Synchronizing unit damaged.
Sliding gear teeth damaged.
Synchronizer keys damaged.
Shifting too fast.
Excessive wear of synchro rings.
Excessive wear of differential side gear liners and
pinion liners.
Damaged synchro springs and/or keys.
Main gear needle bearings worn or damaged.
Excessive wear of driveshaft(s).
Clutch not releasing.
Shift fork detent ball stuck.
Shift linkage damaged, loose or out of adjustment.
Sliding gears tight on shaft splines.
Synchronizer shift keys damaged.
Page 6 - - 8 Workman HD Series