Converting The Speedometer; Hydraulic System Maintenance; Hydraulic System Safety; Checking The Transaxle/Hydraulic-Fluid Level - Toro 07384 Operator's Manual

Converting the
Speedometer
You can convert the speedometer from mph to km/h
or km/h to mph.
1. Park the machine on a level surface, engage the
parking brake, shut off the engine, and remove
the key.
2. Remove the hood; refer to
(page 36).
3. Locate the 2 loose wires next to the
speedometer.
4. Remove the connector plug from the harness
wire and connect the wires together.
Note:
The speedometer switches to km/h or
mph.
5. Install the hood.
Removing the Hood
56
Hydraulic System
Maintenance

Hydraulic System Safety

•
Seek immediate medical attention if fluid is injected
into skin. Injected fluid must be surgically removed
within a few hours by a doctor.
•
Before disconnecting or performing any work on
the hydraulic system, relieve all pressure in the
system by shutting off the engine, cycling the
dump valve from raise to lower, and/or lowering
the cargo bed and attachments. Place the remote
hydraulics lever in the float position. Do not work
under a raised bed without the proper bed safety
support in place.
•
Ensure that all hydraulic-fluid hoses and lines are
in good condition and that all hydraulic connections
and fittings are tight before applying pressure to
the hydraulic system.
•
Keep your hands and body away from pinhole
leaks or nozzles that eject high-pressure hydraulic
fluid.
•
Use cardboard or paper to find hydraulic leaks.
Checking the
Transaxle/Hydraulic-Fluid
Level
Service Interval: Before each use or daily—Check
the transaxle/hydraulic-fluid level.
(Check the fluid level before the
engine is first started and every 8
hours or daily, thereafter.)
Transaxle-fluid type: Dexron III ATF
1. Park the machine on a level surface.
2. Fully lower the cargo bed.
3. Engage the parking brake.
4. Shut off the engine and remove the key.
5. Clean the area around the dipstick (Figure 69).