Toro Workman HDX Service Manual page 105

24.Disassemble reduction shaft assembly:
A. Use a bearing puller to remove bearing (item 1)
from reduction shaft.
B. Remove gear (item 2), helical gear (item 3), collar
(item 4) and gear (item 5).
C. Use a bearing puller to remove bearing (item 6).
D. Remove washer (item 7), needle bearing (item 9)
and gear (item 8).
E. Remove spacer (item 10).
F. Remove snap ring (item 11).
G. Remove shifter (item 12) together with spring,
hub and three (3) keys.
H. Remove key (item 13).
I. Remove synchro ring (item 14) from gear (item
15).
J. Remove gear (item 15), needle bearing (item 16)
and thrust washer (item 17). Inspect needle bearing
and replace if necessary. Measure thickness of
thrust washer. Replace thrust washer if thickness is
less than 0.0709 in. (1.8 mm).
Workman HD Series
1
3
4
2
18
13
18
5
4
3
2
1
Page 6 - - 29
5
13 10
15 14
17 16
12
11
9
Figure 44
12
14
15
16
17
11
Figure 45
Drive Train
7
8
6
6
9 7
8