Toro Workman HDX Service Manual page 134

Inspection
1. Thoroughly clean and dry all parts.
2. Use emery cloth to remove nicks and burrs from all
parts.
3. Measure clearance between groove on shift collar
and shifter block. Replace shifter block if clearance ex-
ceeds 0.039 in. (1.0 mm).
4. Measure I.D. of input shaft bushing (item 1). Replace
bushing if I.D. exceeds 0.673 in. (17.10 mm).
5. Measure O.D. of bushing area on input shaft. Re-
place shaft if O.D. is less than 0.667 in. (16.95 mm). In-
spect surface of bushing area for scoring or damage.
6. Inspect surface of oil seal area on output shaft for
wear or damage.
Drive Train
CLEARANCE
Page 6 - - 58
Figure 125
1
Figure 126
BUSHING
Figure 127
OIL SEAL
Figure 128
Workman HD Series