Toro Workman HDX Service Manual page 116

8. Assemble countershaft:
A. Use a press to install 2 new bearings (item 15)
onto countershaft.
B. Install collar (item 14) and snap ring (item 13).
C. Install washer (item 12) and gear (item 11). Apply
moly disulfide grease into bushing of countershaft
gear before installing. Oil groove on washer must
face the gear.
D. Install collar--spline (item 10) and snap ring (item
8).
E. Install shifter (item 9) onto collar--spline.
F. Install snap ring (item 8), washer (item 7) and in-
ner (item 6). Oil groove on washer must face the
gear.
G. Install gear (item 5).
H. Install washer (item 4) and snap ring (item 3). Oil
groove on washer must face the gear.
I. Install washer (item 2) and a new bearing (item 1)
using a press.
Drive Train
6
4
3
2
1
Page 6 - - 40
Figure 73
16
15
14
13
12
11
10
8
9
8
7
5
Figure 74
Workman HD Series