Toro Workman HDX Service Manual page 108

30.Disassemble differential fork shaft assembly:
A. Remove O--ring (item 1) from fork shaft.
B. Remove snap ring (item 2), washer (item 3) and
spring (item 4).
C. Remove fork (item 5).
D. Remove lock pin (item 6) if necessary.
31.Disassemble axle shaft assemblies:
A. Remove O--ring (item 1) from differential carrier.
B. Remove snap ring (item 2).
C. Remove L.H. axle shaft assembly (item 3).
D. Remove snap ring (item 4) and washer (item 5).
E. Use a bearing puller to remove bearing (item 6)
from axle shaft.
F. Remove oil seal (item 7) from differential carrier
(item 8).
G. Remove R.H. axle shaft assembly (item 1) from
seal cover.
H. Remove snap ring (item 2) and washer (item 3)
from axle shaft.
I. Use a bearing puller to remove bearing (item 4).
J. Remove oil seal (item 5) from seal cover.
Drive Train Page 6 - - 32
Figure 53
L.H. SHAFT
R.H. SHAFT
Figure 54
Workman HD Series