Toro Workman HDX Service Manual page 136

4. Assemble PTO output shaft:
A. If bearing (item 6) was removed, use a press to
install bearing onto output shaft.
B. Install washer (item 5) and retaining ring (item 4).
C. Install retaining ring (item 3) and gear (item 2).
D. Use a press to install bearing (item 1).
5. Use a press to install bearing (item 1) onto intermedi-
ate shaft.
6. Assemble PTO input shaft:
A. Insert spring (item 3) and two (2) steel balls (item
2) into hole.
B. Insert shift collar (item 1) onto input shaft.
C. Move shift collar to "ON" position.
Drive Train
6
2
3
1
1
Page 6 - - 60
5
Figure 132
Figure 133
Figure 134
2
3
2
Figure 135
Workman HD Series
4
7
1