Toro Workman HDX Service Manual page 137

7. Install PTO input shaft sub--assembly:
A. Insert shifter block (item 9) onto pin of shift arm.
Apply moly disulfide grease onto both sides of block
before installing.
B. Put shift collar of PTO input shaft sub--assembly
(item 3) on the shifter block.
C. Install gear (item 7) with bushing and thrust wash-
er (item 6) onto input shaft after sliding the assembly
toward PTO shaft side. Apply moly disulfide grease
to bushing of gear and thrust washer before instal-
ling.
D. Slide two (2) bearings (items 5 and 4) onto input
shaft.
E. Install two (2) retaining rings (items 2 and 1).
Workman HD Series
3
4
Page 6 - - 61
7
5
Figure 136
3
Figure 137
6
7
Figure 138
Moly disulfide
grease
Figure 139
Drive Train
6