Headlights - Toro Workman HDX Service Manual

Headlights

CAUTION
The Workman headlights use a halogen bulb that
becomes extremely hot when in operation. Han-
dling a hot headlight bulb can cause severe
burns and personal injury. Allow enough time for
bulb to cool before handling.
CAUTION
Any surface contamination can damage the
headlight bulb and lead to its failure or explosion
creating a serious safety hazard.
Headlight bulbs should be handled without
touching the clear bulb surface. Handle the bulb
by holding onto the base.
Headlight Disassembly (Fig. 45)
1. Park machine on a level surface, stop engine, apply
parking brake and remove key from ignition switch.
2. Remove hood (see Hood Removal in the Service and
Repairs section of Chapter 7 -- Chassis).
3. If bulb removal is necessary, loosen the bulb from the
headlight by rotating it 1/4 turn counter--clockwise.
Then, grasp bulb base and remove bulb from the head-
light.
4. If necessary, remove headlight from hood.
A. Remove three (3) clips that secure headlight to
hood.
B. Remove headlight from hood.
Headlight Assembly (Fig. 45)
1. If headlight was removed, secure headlight to hood:
A. Insert headlight into hood opening. Make sure
that SPEAKER logo on headlight lens is at bottom.
B. Secure headlight to hood with three (3) clips.
2. If bulb was removed from headlight, align tabs on
bulb with notches in headlight opening. Insert bulb into
back of headlight without touching the clear bulb sur-
face. Secure bulb to headlight by rotating it 1/4 turn
clockwise.
Workman HD Series
3. Install hood (see Hood Installation in the Service and
Repairs section of Chapter 7 -- Chassis). Make sure to
connect the wire harness connector to the headlight dur-
ing hood installation.
3
1. Front hood
2. Clips (3 used per light)
Page 8 - - 33
1
2
Figure 45
3. Headlight (2 used)
Electrical System