Toro Workman HDX Service Manual page 120

13.Assemble shift arms:
A. Install three (3) new oil seals (item 12) into trans-
axle case. Apply multi--purpose grease on lips of oil
seals before installing.
B. Install three (3) keeper plates (item 11) and tight-
en three (3) flange head screws (item 10) to a torque
from 11 to 13 ft- -lb (15 to 17 N- -m).
C. Apply Loctite #680 (or equivalent) to threads and
tapers of shift fork arms.
D. Install two (2) shift arms (item 9). Install shift arm
assembly (items 7, 6, 5, 4, 3 and 2).
E. Install lock nuts (items 8 and 1). Tighten shift arm
retaining lock nuts to a torque from 230 to 240 in- -lb
(26 to 27 N- -m).
14.Install oil cap (item 1) with O--ring. Apply multi--pur-
pose grease to O--ring.
15.If removed, install air breather (item 2). Use sealing
tape on threads of air breather.
Drive Train
230 to 240 in- -lb
(26 to 27 N- -m)
Apply Loctite #680
to threads and tapers
12
1
Page 6 - - 44
1
230 to 240 in- -lb
(26 to 27 N- -m)
7
3
6
5
4
2
8
9
Figure 84
10
11
Figure 85
2
Figure 86
Workman HD Series
8
9