Toro Workman HDX Service Manual page 107

27.Disassemble fork shaft assemblies:
A. Remove lock pin (item 1) from 2nd--3rd fork shaft
assembly.
B. Remove shift fork (item 2) from fork shaft.
C. Remove lock pin (item 1) from 1st--R fork shaft
assembly.
D. Remove fork (item 2) from fork shaft.
28.Disassemble Hi--Lo fork shaft assembly:
A. Remove shift fork (item 1), steel ball (item 2) and
spring (item 3) from Hi--Lo shift fork assembly.
B. Remove E--ring (item 4).
29.Disassemble differential gear assembly:
A. Use a bearing puller to remove bearing (item 1)
from differential case.
B. Remove snap ring (item 2).
C. Use a bearing puller to remove bearing (item 3)
and slider (item 4).
D. Loosen screws (item 5) from ring gear.
E. Remove ring gear (item 6) from differential case
and remove two (2) dowel pins (item 7).
F. Drive lock pin (item 8) out of pinion shaft (item 9).
G. Remove pinion shaft (item 9) from differential
case.
H. Remove two (2) differential pinions (item 10) and
two (2) liners (item 11).
I. Remove L.H. side gear (item 12), R.H. side gear
(item 13) and two (2) liners (item 14).
Workman HD Series
1
2
3
4
Page 6 - - 31
Figure 49
5
4
3
2
Figure 50
Figure 51
11
10
6
9
8
7
14
13
15
5
1
Figure 52
Drive Train
12
14
10
11