Toro Workman HDX Service Manual page 139

10.Install PTO cover:
A. Insert new oil seal into PTO cover. Apply multi--
purpose grease to lip of oil seal.
B. Insert two (2) alignment pins into PTO housing.
C. Apply silicone sealant onto mating surface of PTO
cover.
D. Install PTO cover. Secure cover with cap screws,
nut and lock washers. Torque fasteners from 18 to 22
ft- -lb (24.5 to 29.5 N- -m).
11. Install PTO to transaxle (see PTO Removal and
Installation in this section).
Workman HD Series
Page 6 - - 63
Figure 143
Drive Train