Toro Workman HDX Service Manual page 149

Removal (Fig. 2)
1. Park vehicle on a level surface, shut engine off, re-
move key from ignition switch and apply parking brake.
2. Partially loosen wheel lug nuts that secure wheel to
be removed, then jack up and support vehicle (see Jack-
ing Vehicle in the Safety Instructions section of Chapter
1 -- Safety).
3. Remove lug nuts and then remove wheel assembly
from vehicle.
Installation (Fig. 2)
1. Install wheel. Secure with five (5) lug nuts.
2. Lower vehicle to ground.
WARNING
Failure to maintain proper wheel lug nut torque
could result in failure or loss of wheel and may
result in personal injury. Torque wheel lug nuts
from 80 to 90 ft- -lb (109 to 122 N- -m).
3. Wheel lug nuts should be tightened in a star pattern
(Fig. 3) and in two (2) steps. First, tighten all lug nuts to
40 ft- -lb (55 N- -m) and then torque all lug nuts to a final
torque from 80 to 90 ft- -lb (109 to 122 N- -m).
Workman HD Series
1
Page 7 - - 9
4
2
3
5
Figure 3
Chassis