Toro Workman HDX Service Manual page 29

Fuel Tank Removal (Fig. 8)
1. Park vehicle on a level surface and engage parking
brake. Stop the engine and remove key from ignition
switch. Allow engine to cool.
2. Raise or remove the bed or other attachment(s). If
bed is raised, place safety support on lift cylinder.
3. Disconnect wire harness connectors from fuel pump
and sender on fuel tank.
CAUTION
The fuel supply hose will contain pressurized
fuel. Be careful when disconnecting supply
hose. Wipe up any spilled fuel before starting the
engine.
4. Note routing of fuel hoses for installation purposes
(Fig. 9). Disconnect fuel supply hose from fuel pump/
sender and tank vent hose from rollover valve. Plug fuel
hoses to prevent leakage or contaminant entry.
5. Remove washer head screws (item 18) and retainer
plate (item 14) that secure fuel tank.
6. Remove fuel tank from vehicle.
Fuel Tank Installation (Fig. 8)
1. Position fuel tank to support tube on vehicle.
2. Remove plugs placed in fuel hoses during fuel tank
removal. Connect fuel supply hose to fuel pump/sender
and tank vent hose to rollover valve (Fig. 9). Secure fuel
hoses with hose clamps.
3. Connect wire harness connectors to fuel pump and
sender.
4. Position retainer plate (item 14) to tank and frame.
Make sure that fuel hoses are correctly placed under
plate. While pressing down on retainer plate to best re-
tain tank, install and tighten washer head screws (item
18) to secure fuel tank.
5. Lower or install the bed or other attachment(s).
6. Fill fuel tank. Check for fuel leakage and correct if
found.
Workman HDX
3
1. Retainer plate
2. Fuel supply hose
Page 3 - - 11
2
1
Figure 9
3. Tank vent hose
Briggs/Daihatsu Gasoline Engine