3Rd -- High Lockout Key Switch - Toro Workman HDX Service Manual

3rd - - High Lockout Key Switch
The 3rd -- High lockout key switch has two positions:
SLOW (turtle) and FAST (rabbit). This switch is located
1
on the dash (Fig. 16).
Testing
2
The switch terminals are identified as shown in Figure
17. The circuit wiring of the switch is shown in the chart
below. With the use of a multimeter (ohms setting), the
switch functions may be tested to determine whether
continuity exists between the various switch terminals
for each switch position. Disconnect wire harness con-
nector from 3rd -- High lockout key switch and verify con-
tinuity between switch terminals.
NOTE: The 3rd -- High lockout key switch terminals B
Figure 16
and C are not used on Workman HD series vehicles.
1. Dash 2. 3rd- -High key switch
POSITION CIRCUITS
SLOW B + C
FAST B + C, A + D
SLOW
o
45
FAST
After testing is completed, connect wire harness con-
nector to the 3rd -- High lockout key switch.
Figure 17
Electrical System Page 8 - - 14 Workman HD Series