Removal (Fig. 4)
1. Park vehicle on a level surface and engage parking
brake. Stop the engine and remove key from ignition
switch. Allow engine to cool.
2. Raise or remove the bed or other attachment(s). If
bed is raised, place safety support on lift cylinder.
3. Remove exhaust system components as needed us-
ing Figure 4 as a guide.
4. Discard gaskets and thoroughly clean flange sur-
faces of manifold and muffler.
Workman HD
Installation (Fig. 4)
1. Replace any removed gaskets.
2. Using Figure 4 as a guide, fit all exhaust components
to vehicle before tightening any fasteners. When secur-
ing exhaust, tighten fasteners in the following order:
A. Hex nuts (item 3) that secure manifold to engine.
B. Flange head screw (item 11) that secures muffler
to transaxle.
C. Flange head screws (item 1) and flange nuts
(item 5) that secure muffler to manifold.
D. Flange head screws (item 6) and flange nuts
(item 5) that secure muffler to shift cable mount
bracket.
E. Carriage bolts (item 13) and flange nuts (item 5)
that secure muffler to mount plate.
F. Flange head screw (item 6) and flange nut (item
5) that secures exhaust manifold to bracket (item 8).
3. Lower or install bed or attachment(s).
Page 5 - - 9
Kohler Gasoline Engine