Engine Removal - Toro Workman HDX Service Manual

Engine Removal (Fig. 15)
1. Park vehicle on a level surface and engage parking
brake. Stop the engine and remove key from ignition
switch. Allow engine to cool.
2. Raise or remove the bed or other attachment(s) to
gain access to engine. If bed is raised, place safety sup-
port on lift cylinder.
3. Disconnect negative (--) and then positive (+) battery
cables at the battery.
4. Remove exhaust tube (item 28) from vehicle (see
Exhaust System Removal in this section).
5. Loosen hose clamp (item 31) that secures air intake
hose (item 32) to engine. Remove intake hose from en-
gine.
CAUTION
The fuel supply hose will contain pressurized
fuel. Be careful when disconnecting fuel supply
hose. Wipe up any spilled fuel before starting the
engine.
6. Disconnect fuel hose from engine. Plug end of fuel
hose to prevent contamination and fuel spillage. Posi-
tion disconnected fuel hose away from engine.
7. Note location of cable ties used to secure wire har-
ness leads. Label and disconnect wire harness connec-
tors that attach to engine:
A. Battery cable and fusible link harness from starter
solenoid stud (Fig. 16).
B. Harness wire from spade terminal on starter sole-
noid.
C. Harness wire from oil pressure switch.
D. Harness wires from temperature sender and
thermal fan switch on water pump housing.
E. Harness connector and wire with ring terminal
from alternator.
F. Negative battery cable and harness ground con-
nector secured to engine mount (Fig. 16). Note loca-
tion of ground connections and flange head screw for
assembly purposes.
G. Six (6) harness wires from ignition coils.
H. All harness connectors from engine sensors and
fuel injectors.
Workman HDX
1. Engine
2. Flat washer
3. Harness alternator wire
4. Nut
5. Positive cable
1
5
8
1. Cap screw
2. Flange nut
3. R- -clamp
4. Engine support
Page 3 - - 19
2
10
8
9
Figure 16
6. Nut
7. Flange head screw
8. Negative cable
9. Fusible link harness
10. Harness ground wire
1
6
7
7
6
2
Figure 17
5. Engine mount
6. Snubbing washer
7. Engine mount assembly
Briggs/Daihatsu Gasoline Engine
1
3
4
5
6
7
3