Toro Workman HDX Service Manual page 106

25.Disassemble reverse shaft assembly:
A. Use a bearing puller to remove bearing (item 1)
from reverse shaft.
B. Remove gear (item 2).
C. Use a bearing puller to remove bearing (item 3)
from reverse shaft.
26.Disassemble countershaft assembly:
A. Use a bearing puller to remove bearing (item 1)
from countershaft.
B. Remove thrust washer (item 2) and snap ring
(item 3).
C. Remove thrust washer (item 4) and gear (item 5).
D. Remove inner (item 6) and thrust washer (item 7).
Inspect inner for wear and damage. Replace inner if
O.D. is less than 1.258 in. (31.95 mm). Measure
thickness of thrust washer. Replace thrust washer if
thickness is less than 0.0709 in. (1.8 mm).
E. Remove two (2) snap rings (item 8).
F. Remove Hi--Lo shifter (item 9) and collar spline
(item 10).
G. Remove gear (item 11). Inspect bushing for wear
and damage. Replace gear if I.D. exceeds 1.184 in.
(30.08 mm).
H. Remove washer (item 12), snap ring (item 13)
and collar (item 14). Measure thickness of washer
and replace washer if thickness is less than 0.110 in.
(2.8 mm)
I. Use a bearing puller to remove two (2) bearings
(item 15).
Drive Train
6
4
3
2
1
Page 6 - - 30
Figure 46
Figure 47
16
15
14
13
12
11
10
8
9
8
7
5
Figure 48
Workman HD Series