Toro Workman HDX Service Manual page 102

18.To remove shift arms:
A. Loosen and remove nut (item 1). Remove
2nd--3rd shift arm (item 2) together with shift arm
plate (item 3), spring (item 4), locknut (item 5), wash-
er (item 6) and cap screw (item 7).
B. Loosen and remove locknut (item 8) from both
1st--Rev. shift arm (item 9) and High--Low shift arm
(not shown). Remove shift arms.
C. Loosen cap screws (Fig. 38, item 10) and remove
keeper plates (item 11).
D. Remove oil seals (item 12).
E. Inspect shift arms and keeper plates for bending
or damage and replace if necessary.
19.If PTO cover is on transaxle, remove five (5) cap
screws (item 1) and nut (item 2) with washer. Separate
PTO cover (item 3) from transaxle case. Inspect PTO
cover for cracks or damage and replace if necessary.
Drive Train
12
11
Page 6 - - 26
1
3
7
5 6
4
2
8
9
Figure 37
10
Figure 38
2
Figure 39
Workman HD Series
3
1