Toro Workman HDX Service Manual page 53

Removal (Fig. 4)
1. Park vehicle on a level surface and engage parking
brake. Stop the engine and remove key from ignition
switch. Allow engine to cool.
2. Raise or remove the bed or other attachment(s). If
bed is raised, place safety support on lift cylinder.
3. Remove air cleaner components as needed using
Figure 4 and 5 as guides.
Installation (Fig. 4)
IMPORTANT: Any leaks in the air filter system will
cause serious engine damage. Make sure daily that
all air cleaner components are in good condition
and are properly secured during reassembly.
1. Assemble air cleaner system using Figure 4 and 5 as
guides. Air cleaner hose (item 2) and air inlet hood (item
3) should be positioned straight upward. The vacuator
valve on the air cleaner assembly should be positioned
downward.
2. Lower or install bed or attachment(s).
Workman HDX--D
2
6
1. Plug
2. Upper housing
3. Air filter element
Page 4 - - 7
1
3
4
5
Figure 5
4. Gasket
5. Lower housing
6. Vacuator valve
Briggs/Daihatsu Diesel Engine