Dodge 2004 Neon SX2 Diagnostic Manual page 91

AUDIO
ALL OUTPUTS SHORT —
TEST
2 Turn the ignition off.
NOTE: Perform this procedure after disconnecting each front speaker
connector.
Disconnect each front speaker harness connector one at a time.
Turn the ignition on.
Turn the radio on.
With the DRBIII , erase the audio DTCs.
Cycle the ignition switch from off to on and wait 10 seconds.
With the DRBIII , read DTC's.
Does the DRBIII
disconnected?
Yes → Go To 3
→ Replace the Speaker that when disconnected the DTC did not
No
3 Turn the ignition off.
NOTE: Perform this procedure after disconnecting each I/P speaker con-
nector.
Disconnect each I/P speaker harness connector one at a time.
Turn the ignition on.
Turn the radio on.
With the DRBIII , erase the audio DTCs.
Cycle the ignition switch from off to on and wait 10 seconds.
With the DRBIII , read DTC's.
Does the DRBIII
disconnected?
Yes → Go To 4
→ Replace the Speaker that when disconnected the DTC did not
No
4 Turn the ignition off.
NOTE: Perform this procedure after disconnecting each rear speaker
connector.
Disconnect each rear speaker harness connector one at a time.
Turn the ignition on.
Turn the radio on.
With the DRBIII , erase the audio DTCs.
Cycle the ignition switch from off to on and wait 10 seconds.
With the DRBIII , read DTC's.
Does the DRBIII
disconnected?
Yes → Go To 5
→ Replace the Speaker that when disconnected the DTC did not
No
Continued
ACTION
display ALL OUTPUTS SHORT with all the front speakers
reset.
Perform BODY VERIFICATION TEST - VER 1.
display ALL OUTPUTS SHORT with all the I/P speakers
reset.
Perform BODY VERIFICATION TEST - VER 1.
display ALL OUTPUTS SHORT with all the rear speakers
reset.
Perform BODY VERIFICATION TEST - VER 1.
84
APPLICABILITY
All
All
All