P1105-Tip Sensor Solenoid Circuit - Dodge 2004 Neon SX2 Diagnostic Manual

Symptom:

P1105-TIP SENSOR SOLENOID CIRCUIT

When Monitored and Set Condition:
P1105-TIP SENSOR SOLENOID CIRCUIT
When Monitored: The ignition on or the engine running. Battery voltage greater than
10.4 volts or in turbo boost mode.
Set Condition: The PCM will set the DTC if the actual state of the solenoid does not
match the intended state.
GOOD TRIP EQUAL TO ZERO
TIP SOLENOID OPERATION
(F12) FUSED IGNITION SWITCH OUTPUT CIRCUIT
(K55) TIP SOL CONTROL CIRCUIT SHORTED TO BATTERY VOLTAGE
(K55) TIP SOL CONTROL CIRCUIT OPEN
(K55) TIP SOL CONTROL CIRCUIT SHORTED TO GROUND
PCM
TEST
1 Ignition on, engine not running.
With the DRBIII , read PCM DTCs and record the related Freeze Frame data.
Is the Good Trip displayed and equal to zero?
Yes → Go To 2
No
2 Turn the ignition off.
Disconnect the TIP Solenoid harness connector.
Using a 12-volt test light, jumper across the TIP Solenoid harness connector.
NOTE: While actuating the solenoid wiggle the related wiring harness.
With the DRBIII , actuate the TIP Solenoid.
Does the test light illuminate brightly and flash on and off?
Yes → Replace the TIP Solenoid.
No
POSSIBLE CAUSES
ACTION
→ Refer to the INTERMITTENT CONDITION symptom in the
Driveability category.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
→ Go To 3
DRIVEABILITY - NGC
247
APPLICABILITY
All
All