Dodge 2004 Neon SX2 Diagnostic Manual page 536

DRIVEABILITY - NGC
P0516-BATTERY TEMPERATURE SENSOR LOW —
TEST
3 Turn the ignition off.
Disconnect the Battery Temp Sensor harness connector.
Disconnect the PCM harness connector.
Measure the resistance between ground and the (K118) Battery Temp Signal circuit
in the Battery Temp Sensor harness connector.
Is the resistance below 100 ohms?
Yes → Repair the short to ground in the (K118) Battery Temp Signal
→ Go To 4
No
4 Turn the ignition off.
Disconnect the Battery Temp Sensor harness connector.
Disconnect the PCM harness connector.
Measure the resistance between the (K118) Battery Temp Signal circuit and the
(K167) Sensor ground circuit in the Battery Temp Sensor harness connector.
Is the resistance below 100 ohms?
Yes → Repair the (K167) Sensor ground shorted to the (K118) Battery
→ Go To 5
No
5 NOTE: Before continuing, check the PCM harness connector terminals for
corrosion, damage, or terminal push out. Repair as necessary.
If there are no possible causes remaining, view repair.
Repair
ACTION
circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Temp Sensor Signal circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Replace and program the Powertrain Control Module in accor-
dance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
200
Continued
APPLICABILITY
All
All
All