Dodge 2004 Neon SX2 Diagnostic Manual page 66

PASSENGER SQUIB 1 CIRCUIT OPEN —
TEST
2 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BE-
FORE PROCEEDING.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE
DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO THE AIR
IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN SERIOUS OR
FATAL INJURY.
Disconnect the Passenger Airbag.
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool to the Passenger Airbag connector.
WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN IGNITION
ON, THEN RECONNECT THE BATTERY.
With the DRBIII , read the active Airbag DTCs.
Does the DRBIII show PASSENGER SQUIB 1 CIRCUIT OPEN?
Yes → Go To 3
→ Replace the Passenger Airbag in accordance with the Service
No
3 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BE-
FORE PROCEEDING.
Disconnect the Airbag Control module connector.
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool adaptor to the Airbag Control Module connector.
Disconnect the Load Tool from the Passenger Airbag connector.
Measure the resistance of the Passenger Squib 1 Line 1 and Line 2 circuit between
the ACM Adaptor and the Passenger Airbag connector.
Is the resistance below 1.0 ohms on both circuits?
Yes → Replace the Airbag Control Module in accordance with Service
→ Repair open or high resistance in Passenger Squib 1 Line 1 or
No
ACTION
Information.
Perform AIRBAG VERIFICATION TEST - VER 1.
Instructions.
Perform AIRBAG VERIFICATION TEST - VER 1.
Line 2 circuits.
Perform AIRBAG VERIFICATION TEST - VER 1.
Continued
59
AIRBAG
APPLICABILITY
All
All