Dodge 2004 Neon SX2 Diagnostic Manual page 538

DRIVEABILITY - NGC
P0517-BATTERY TEMPERATURE SENSOR HIGH —
TEST
3 Turn the ignition off.
Disconnect the Battery Temp harness connector.
Connect a jumper wire between the Battery Temp Signal circuit and the Sensor
ground circuit in the Battery Temp harness connector.
Ignition on, engine not running.
With the DRBIII , read the Battery Temp Sensor voltage.
Is the voltage below 1.0 volt?
Yes → Replace the Battery Temp Sensor.
→ Go To 4
No
4 Turn the ignition off.
Disconnect the Battery Temp Sensor harness connector.
Disconnect the PCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Measure the resistance of the (K118) Battery Temp Signal circuit from the Battery
Temp Sensor harness connector to the appropriate terminal of special tool #8815.
Is the resistance below 5.0 ohms?
Yes → Go To 5
→ Repair the open in the (K118) Battery Temp Signal circuit.
No
5 Turn the ignition off.
Disconnect the Battery Sensor harness connector.
Disconnect the PCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Measure the resistance of the (K167) Sensor ground circuit from the Battery Temp
Sensor harness connector to the appropriate terminal of special tool #8815.
Is the resistance below 5.0 ohms?
Yes → Go To 6
→ Repair the open in the (K167) Sensor ground circuit.
No
6 NOTE: Before continuing, check the PCM harness connector terminals for
corrosion, damage, or terminal push out. Repair as necessary.
If there are no possible causes remaining, view repair.
Repair
ACTION
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Replace and program the Powertrain Control Module in accor-
dance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
202
Continued
APPLICABILITY
All
All
All
All