Dodge 2004 Neon SX2 Diagnostic Manual page 239

VEHICLE THEFT/SECURITY
*VTSS INDICATOR STAYS ON STEADY DURING ARMING —
TEST
6 Disconnect the Remote Keyless Entry Module connector.
Measure the resistance of the Decklid Security Switch Sense circuit to ground.
Is the resistance below 10.0 ohms?
Yes → Replace the Remote Keyless Entry Module.
→ Go To 7
No
7 Disconnect the Decklid Security Switch connector (behind decklid lock cylinder).
Using a 12-volt Test Light connected to 12-volts, test the Ground circuit for
continuity.
Does the light illuminate?
Yes → Go To 8
→ Repair the Decklid Security Switch Ground circuit for an open.
No
8 Turn the ignition off.
Disconnect the Remote Keyless Entry Module connector.
Disconnect the Decklid Security Switch connector (behind decklid lock cylinder).
Connect a jumper wire between the Decklid Security Switch Sense circuit and
ground.
Measure the resistance of the Decklid Security Switch Sense circuit in the RKE
module connector.
Is the resistance below 5.0 ohms?
Yes → Replace the Decklid Security Switch.
→ Repair the Decklid Security Switch Sense circuit for an open.
No
ACTION
Perform VTSS VERIFICATION TEST - 1A.
Perform VTSS VERIFICATION TEST - 1A.
Perform VTSS VERIFICATION TEST - 1A.
Perform VTSS VERIFICATION TEST - 1A.
232
Continued
APPLICABILITY
All
All
All