Dodge 2004 Neon SX2 Diagnostic Manual page 674

VERIFICATION TESTS
Verification Tests —
POWERTRAIN VERIFICATION TEST VER - 1
1. NOTE: After completing the Powertrain Verification Test the Transmission Verifi-
cation Test must be performed.
2. NOTE: If the PCM has been replace and the vehicle is equipped with a 2.4L Turbo,
Manual Transmission, the Pinion Factor MUST be programmed into the PCM.
Failure to do so will cause the speedometer to become inoperative or inaccurate.
3. NOTE: If the PCM has been replaced and the correct VIN and mileage have not
been programmed, a DTC will be set in the ABS Module, Airbag Module and the
SKIM.
4. NOTE: If the vehicle is equipped with a Sentry Key Immobilizer System, Secret Key
data must be updated. Refer to the Service Information for the PCM, SKIM and the
Transponder (ignition key) for programming information.
5. Inspect the vehicle to ensure that all components related to the repair are connected properly.
6. Inspect the engine oil for fuel contamination. Replace the oil and filter as necessary.
7. Attempt to start the engine.
8. If the No Start condition is still present, refer to the symptom list and perform the diagnostic
testing as necessary. refer to and Technical Service Bulletins that may apply.
9. Run the engine for one warm-up cycle to verify operation.
10. With the DRBIII , confirm that no DTCs or Secondary Indicators are present and that all
components are functioning properly.
11. If a DTC is present, refer to the appropriate category and select the corresponding symptom.
Are any DTCs present?
Yes → Repair is not complete, refer to appropriate symptom.
→ Repair is complete.
No
POWERTRAIN VERIFICATION TEST VER - 2 - NGC
1. NOTE: After completing the Powertrain Verification Test the Transmission Verifi-
cation Test must be performed.
2. NOTE: If the PCM has been replace and the vehicle is equipped with a 2.4L Turbo,
Manual Transmission, the Pinion Factor MUST be programmed into the PCM.
Failure to do so will cause the speedometer to become inoperative or inaccurate.
3. NOTE: If the PCM has been replaced and the correct VIN and mileage have not
been programmed, a DTC will be set in the ABS Module, Airbag Module and the
SKIM.
4. NOTE: If the vehicle is equipped with a Sentry Key Immobilizer System, Secret Key
data must be updated. Refer to the Service Information for the PCM, SKIM and the
Transponder (ignition key) for programming information.
5. Inspect the vehicle to ensure that all components related to the repair are connected properly.
6. With the DRBIII , clear DTCs and Reset Memory all engine values.
7. Run the engine for one warm-up cycle to verify proper operation.
8. Road test the vehicle. Use all accessories that may be related to this repair.
9. With the DRBIII , confirm that no DTC's or Secondary Indicators are present and that all
components are functioning properly.
10. If this test is being performed after a No Trouble Code test, verify the symptom is no longer
present.
11. If the symptom is still present, or any other symptom or DTC is present refer to the
appropriate category and perform the corresponding symptom.
12. Refer to any Technical Service Bulletins that may apply.
13. If there are no DTCs present and all components are functional properly, the repair is
complete.
Are any DTCs present?
Yes → Repair is not complete, refer to appropriate symptom.
→ Repair is complete.
No
Continued
338
APPLICABILITY
All
APPLICABILITY
All