Dodge 2004 Neon SX2 Diagnostic Manual page 232

*OPEN PASSENGER DOOR FAILS TO TRIP ALARM —
TEST
3 Open the Passenger Door.
Disconnect the Passenger Door Lock Motor/Ajar Switch connector.
Close all the other passenger doors.
Connect a jumper wire from the Passenger Door Ajar/RKE Sense circuit to ground.
With the DRBIII select: THEFT ALARM, VTSS, INPUT/OUTPUT.
With the DRBIII , read the PASS DOOR AJAR SW state.
Does the DRBIII show: CLOSED?
Yes → Replace the Passenger Door Lock Motor/Ajar Switch.
→ Repair the Door Ajar Switch Sense circuit for an open between the
No
4 Disconnect the Passenger Door Ajar switch connector.
Using a 12-volt Test Light connected to 12-volts, test the Ground circuit for
continuity.
Does the light illuminate?
Yes → Go To 5
→ Repair the Left Rear Door Ajar Switch Ground circuit for an open.
No
5 Open the Left Rear Door.
Disconnect the Left Rear Door Ajar Switch connector.
Close all the other Passenger Doors.
Connect a jumper wire from the Passenger Door Ajar/RKE Sense circuit to ground.
With the DRBIII select: THEFT ALARM, VTSS, INPUT/OUTPUT.
With the DRBIII , read the PASS DOOR AJAR SW state.
Does the DRBIII show: CLOSED?
Yes → Replace the Left Rear Door Ajar Switch.
→ Repair the Door Ajar Switch Sense circuit for an open between the
No
6 Disconnect the Driver Door Ajar switch connector.
Using a 12-volt Test Light connected to 12-volts, test the Ground circuit for
continuity.
Does the light illuminate?
Yes → Go To 7
→ Repair the Right Rear Door Ajar Switch Ground circuit for an
No
ACTION
Perform VTSS VERIFICATION TEST - 1A.
door ajar switch and the splice.
Perform VTSS VERIFICATION TEST - 1A.
Perform VTSS VERIFICATION TEST - 1A.
Perform VTSS VERIFICATION TEST - 1A.
door ajar switch and the splice.
Perform VTSS VERIFICATION TEST - 1A.
open.
Perform VTSS VERIFICATION TEST - 1A.
VEHICLE THEFT/SECURITY
225
Continued
APPLICABILITY
All
All
All
All