Dodge 2004 Neon SX2 Diagnostic Manual page 484

DRIVEABILITY - NGC
P0340-CAMSHAFT POSITION SENSOR CIRCUIT —
TEST
15 Turn the ignition off.
Disconnect the CMP Sensor harness connector.
Ignition on, engine not running.
Measure the voltage of the (K7) 5 Volt Supply circuit in the CMP Sensor harness
connector.
Is the voltage above 5.5 volts?
Yes → Repair the short to battery voltage in the (K7) 5 Volt Supply
→ Go To 16
No
16 NOTE: Before continuing, check the PCM harness connector terminals for
corrosion, damage, or terminal push out. Repair as necessary.
If there are no possible causes remaining, view repair.
Repair
ACTION
circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Replace and program the Powertrain Control Module in accor-
dance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
148
Continued
APPLICABILITY
All
All