*DRIVER DOOR FAILS TO LOCK & UNLOCK —
TEST
4
Remove the inner door trim panel to gain access to the Door Lock Motor connector.
Disconnect the Door Lock Motor connector.
Disconnect the Remote Keyless Entry module connector.
Measure the resistance of the Driver Door Unlock Relay Output wire between the
RKE connector and the door lock motor connector.
Is the resistance below 5.0 ohms?
Yes → Test Complete.
→ Repair the open Driver Door Unlock Relay Output wire.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
POWER DOOR LOCKS/RKE
Continued
207
APPLICABILITY
All