Dodge 2004 Neon SX2 Diagnostic Manual page 33

AIRBAG
DRIVER SQUIB 1 CIRCUIT OPEN —
TEST
2 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BE-
FORE PROCEEDING.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE
DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO THE AIR
IF ACCIDENTALLY DEPLOYED. FAILURETO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND PERSONAL INJURY OR DEATH.
Disconnect the Driver Airbag.
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool to the Driver Airbag connectors.
WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION ON, THEN RECONNECT THE BATTERY.
With the DRBIII , read the active Airbag DTCs.
Does the DRBIII show DRIVER SQUIB 1 CIRCUIT OPEN?
Yes → Go To 3
→ Replace the Driver Airbag in accordance with the Service Infor-
No
3 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BE-
FORE PROCEEDING.
Disconnect the Clockspring connector.
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool to the Clockspring connector.
WARNING: TO AVOID PERSONAL INJURY OR DEATH,TURN THE IGNI-
TION ON, THEN RECONNECT THE BATTERY.
With the DRBIII , read the active Airbag DTCs.
Does the DRBIII show DRIVER SQUIB 1 CIRCUIT OPEN?
Yes → Go To 4
→ Replace the Clockspring in accordance with the Service Informa-
No
4 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BE-
FORE PROCEEDING.
Disconnect the Airbag Control Module connector.
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool adaptor to the Airbag Control Module connector.
Disconnect the Load Tool from the Clockspring connector.
Measure the resistance of the Driver Squib 1 Line 1 and Line 2 circuit between the
ACM adaptor and the Clockspring connector.
Is the resistance below 1.0 ohms on both circuits?
Yes → Go To 5
→ Repair open or high resistance in the Driver Squib 1 Line 1 or
No
ACTION
mation.
Perform AIRBAG VERIFICATION TEST - VER 1.
tion.
Perform AIRBAG VERIFICATION TEST - VER 1.
Line 2 circuit.
Perform AIRBAG VERIFICATION TEST - VER 1.
Continued
26
APPLICABILITY
All
All
All