Dodge 2004 Neon SX2 Diagnostic Manual page 778

P0713-TRANSMISSION TEMPERATURE SENSOR HIGH —
TEST
2 With the DRBIII , check Transmission DTC's.
Are there any Speed Sensor DTCs present?
Yes → Refer to the Transmission category and perform the appropriate
→ Go To 3
No
3 With the DRBIII , Check the STARTS SINCE SET counter for P0713.
NOTE: This counter only applies to the last DTC set.
Is the STARTS SINCE SET counter 2 or less?
Yes → Go To 4
→ Go To 9
No
4 Turn the ignition off to the lock position.
Remove the Starter Relay.
CAUTION: Removal of the Starter Relay is to prevent a Transmission, NO
RESPONSE, condition and disable the starter.
Install the Transmission Simulator, Miller tool #8333 and the Electronic Transmis-
sion Adapter kit 8333-1A.
Note: Check connectors - Clean/repair as necessary.
Ignition on, engine not running.
With the Transmission Simulator, turn the Input/Output switch to OFF.
With the DRBIII , monitor the TRANS TEMP VOLTS while turning the Thermistor
Voltage switch to all three positions on the Transmission Simulator.
Compare the DRBIII
Simulator.
Do the readings on the Transmission Simulator match the DRBIII readings ± 0.2
volts?
Yes → Go To 5
→ Go To 6
No
5 If there are no possible causes remaining, view repair.
Repair
ACTION
symptom.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
readings with the numbers listed on the Transmission
Replace Transmission Solenoid/TRS assembly per the Service
Information.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
TRANSMISSION - NGC
57
Continued
APPLICABILITY
All
All
All
All