Dodge 2004 Neon SX2 Diagnostic Manual page 198

PASSENGER DOOR SWITCH FAILURE —
TEST
3 NOTE: This test is for an EXPORT vehicle only. If this is a DOMESTIC
vehicle, answer YES to the question and continue.
Turn the ignition off.
Disconnect the Remote Keyless Entry module connector.
Remove the passenger door inner trim panel.
Disconnect the Cylinder Lock Switch connector.
Measure the resistance between ground and the passenger Door Switch Mux circuit
(cavity 11).
Is the resistance below 8000.0 ohms?
Yes → Go To 4
→ Replace the Cylinder Lock Switch.
No
4 Turn the ignition off.
Disconnect the Door Lock Switch connector.
Disconnect the Remote Keyless Entry module connector.
Measure the resistance between ground and the passenger Door Switch Mux circuit
(cavity 11).
Is the resistance below 8000.0 ohms?
Yes → Repair the passenger Door Switch Mux circuit for a short to
→ Replace the Door Lock Switch.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
ground.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
POWER DOOR LOCKS/RKE
Continued
191
APPLICABILITY
All
All