Dodge 2004 Neon SX2 Diagnostic Manual page 160

*ALL GAUGES INOPERATIVE —
TEST
4 Turn the ignition off.
Inspect the #11 Fuse in the Fuse Block for LHD vehicles (#12 Fuse for LHD autostick
equipped vehicles); #10 Fuse in the Fuse Block for RHD vehicles (#9 Fuse for RHD
autostick equipped vehicles).
If the fuse is open, replace with proper rated fuse.
Turn the ignition on for one minute.
Turn the ignition off.
Inspect the #11 Fuse in the Fuse Block for LHD vehicles (#12 Fuse for LHD autostick
equipped vehicles); #10 Fuse in the Fuse Block for RHD vehicles (#9 Fuse for RHD
autostick equipped vehicles).
Is the fuse open?
Yes → Repair the Fused Ignition Switch Output circuit for a short to
→ Go To 5
No
5 Turn the ignition off.
Disconnect the Instrument Cluster harness connector.
Turn the ignition on.
Measure the voltage between the Fused Ignition Switch Output circuit (pin 15) and
ground. For autostick equipped vehicles, also measure the voltage between the Fused
Ignition Switch Output circuit (pin 9) and ground.
Is the voltage above 10.5 volts?
Yes → Go To 6
→ Repair the Fused Ignition Switch Output circuit for an open.
No
6 Turn the ignition off.
Disconnect the Instrument Cluster harness connector.
Measure the resistance between ground and the Instrument Cluster Ground circuit.
Is the resistance below 5.0 ohms?
Yes → Replace the Instrument Cluster in accordance with the Service
→ Repair the Instrument Cluster Ground circuit for an open.
No
Continued
ACTION
ground.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Information.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
INSTRUMENT CLUSTER
153
APPLICABILITY
All
All
All