Module Previously Configured For Vtss - Dodge 2004 Neon SX2 Diagnostic Manual

Symptom:

MODULE PREVIOUSLY CONFIGURED FOR VTSS

When Monitored and Set Condition:
MODULE PREVIOUSLY CONFIGURED FOR VTSS
When Monitored: With the ignition on during the configuration of the Remote Keyless
Entry Module.
Set Condition: If the configuration of the module type has been previously set for VTSS,
an attempt to set the module for non-VTSS will cause the new configuration to fail. This
code should only appear if attempting to re-configure a used RKE module.
REMOTE KEYLESS ENTRY MODULE
TEST
1 The RKE module attempting to be configured to non-VTSS, has originally been
configured to be used on a VTSS equipped vehicle.
If the vehicle is NOT VTSS equipped (does not have either a hood ajar or a decklid
security switch (knockout)) the RKE module attempting to be configured should be
replaced.
If there are no possible causes remaining, view repair.
Repair
POSSIBLE CAUSES
ACTION
Replace the Remote Keyless Entry Module.
Perform VTSS VERIFICATION TEST - 1A.
VEHICLE THEFT/SECURITY
215
APPLICABILITY
All