Dodge 2004 Neon SX2 Diagnostic Manual page 401

P0112-INTAKE AIR TEMPERATURE SENSOR LOW —
TEST
4 Turn the ignition off.
Disconnect the IAT Sensor harness connector.
Disconnect the PCM harness connector.
Measure the resistance between the (K21) IAT Sensor Signal circuit and the (K4)
Sensor ground circuit in the IAT Sensor harness connector.
Is the resistance below 100 ohms?
Yes → Repair the (K167) Sensor ground shorted to the (K21) IAT Signal
→ Go To 5
No
5 NOTE: Before continuing, check the PCM harness connector terminals for
corrosion, damage, or terminal push out. Repair as necessary.
If there are no possible causes remaining, view repair.
Repair
ACTION
circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Replace and program the Powertrain Control Module in accor-
dance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
DRIVEABILITY - NGC
65
Continued
APPLICABILITY
All
All